return to newsletter 2002 issue 2
return home

BUILDING A CAGE?

Let's start this project by using pre-cut cage kits.  The size of the cage and the type of wire used can vary as much as the kind of bunny that will inhabit this new home.  There should be four sides, a top, a bottom (floor), a door and a door latch with every kit.  J-clips or c-rings along with the appropriate tool are necessary to connect the 7 pieces together.
Start by putting the four side pieces in their proper locations.  One side should have a door hole opening.
Put the j-clips or c-rings about every two to three inches apart on the sides and top edges.  Add more clips around the bottom edges and top corners to help reinforce those areas.
Connect all four sides and set the cage on its bottom edges. 
Attach the top to the cage.
Turn the cage upside and attach the bottom piece.  Make sure the half-inch side of the bottom wire is on the inside of the cage.
You can put the bottom wire up and inch or two so the floor will be recessed if the cage is to be used in a drop pan.
Next attach the door and door latch.  Doors using "T" latches should be connected on the top side and on the inside of the door opening.  Doors with spring door latches can be connected on the bottom or side of the door opening but only on the outside of the cage.
The size and location of the door opening is important.  The hole should be large enough to get the rabbit in & out easily.  Also the door holes needs to be large enough to get a Nestbox in & out if needed.
The opening is usually small enough to allow room for an attached feeder and water supply on the cage front.
Use door edge guard on door hole edges.  This can prevent your arms or the bunny from getting scratched.
To help prolong the usefulness of the cage, keep it as clean and dry as possible.
Have fun, Ken